Overhead Line Connectors Plastic TTD Series Electrical Insulation Piercing Connector Waterproof Clamp for ABC Cable Connecting

Insulation Piercing Connector (IPC):
1. Piercing connector, simple installation, need not strip the cable coat
2. Moment nut, piercing pressure is constant, keep good electric connection and make no damage to lead.
3. Self-seam frame,wetproof,waterproof,and anti-corrosion,extend the using life of insulated lead and connector.
4. Adopted special connecting tablet, apply to joint of Cu(AI) and Cu(AI) or Cu and AI.
5. Small electric connecting resistance, connecting resistance less than 2.5 times of the resistance of branch conductor with the
same length . in accordance with the standard DL/T765.1-2001
6. Special insulated case body, resistance to illumination and environmental aging, the insulation strength can up to 12kV.
7. Arc surface design , apply to connection with the same (differnet) diameter, wide connection scope (0.75mm2-400mm2/td)

Instructions:

TTD series insulation piercing connector is not only used to connect the (or separate) the self-supporting insulated wire, but also used to separate lighting circuit.

1).Adjust the connector nut to suitable location.

2).Put the branch wire into the cap sheath fully.

3).Insert the main wire, if there are two lays of insulated lay in the main cable, should strip a certain length of the first insulated lay from inserted end.

4).Turn the nut by hand, and fix the connector in suitable location.

5).Screw the nut with the sleeve spanner.

6).Screw the nut continually until the top part is cracked and dropped down.